Image Armor Ink for all Epson Based Garment Printers including the DTG, Anajet, Neoflex, Fast T-Jet, Veloci-Jet, TexJet, FreeJet, IDot, Mod1 and many more (see below).
IMAGE ARMOR E-SERIES INK has a 35 second cure time!*(CMYK only, White is 90 seconds.)
IMAGE ARMOR E-SERIES INK was formulated to "play nice" with all your printer components. This means your wiper and capping station will have less build up and will be easier to clean.
IMAGE ARMOR E-SERIES INK has done an amazing job improving the cure time, but they didn't stop there. They made it their mission to improve the brightness of their inks AND the washability too. These high standards have resulted in longer lasting, better looking prints wash after wash. It's almost shocking to see how they look after 30 washes!
Instructions for curing Image Armor Ink:
- Cure the Image Armor Inks at 356F for 35 seconds(CMYK)/90 seconds(White). You can go a little longer on the cure time, however best results are achieved at the suggested time and temperature
- Use light to medium pressure on the heat press to cure the ink.
- Allow for 24 hours after heat pressing before washing the shirt. This allows continued curing of the ink. Washing immediately will result in about a 10-15% decrease in print quality life.
Since the new E-SERIES inks are being released for all of the Epson® repurposed printers you might be wondering if you will be able to use them. Some of the printers include (but not limited to):
*Bottle Sizes may vary during covid. Bottle sizes are approximate and can vary depending on settling.
||Compatible with E-series Ink
||Sprint, FP-125, SP200
||Kiosks, HM1, Viper, M2, M4
||Melco-Jet, G2, G3
||Spectra 3000 and Spectra 3880
||T-Jet, T-Jet 2, T-Jet 3, Blazer Express, Pro
||I-Dot 2100, 4200 and M-Link OV1
||FreeJet 300TX, 500TX and 700TX
||Texjet, SuperJet and TexJet Plus
||Rjet-i3, Rjet-R4 and Rjet-R5
||Any Epson Based DIY Printer
||MS Zero, MS-One, Advantage,